Marantec 115694 Manuel d'instructions télécharger pdf (Page 14)

8-12. INSTALL PHOTO EYE SAFETY SYSTEM

MOUNTING THE PHOTO EYE SENSOR BRACKETS TO WALL:

 Locate the mounting position for brackets photo eye beam will

have a clear path from one side of door to other side.

After mounting, the photo eye beam must have a clear path

from one side of the door to the other.

 Use the bracket mounting holes as a template to locate an drill (2)

3/16" diameter pilot holes on both sides of the garage door as shown

in Fig. 29.

 Secure the bracket with 1/4" x 1-1/2" lag screws provided as shown

in Fig. 29.

MOUNTING THE PHOTO EYE SENSORS TO MOUNTING

BRACKET. Fig. 30

 Install the sensors to the mounting bracket by inserting bend

clips of sensor bracket through the vertical slot on mounting

bracket.

 Insert straight clips through other set of vertical slot on the mounting

bracket.

 Twist one of the straight clips slightly to lock the sensor in place

once inserted through vertical slot on the mounting bracket.

 Repeat the above procedure for the other sensor.

To provide the maximum amount of protection, the photo eye

sensors must be mounted between 3.5” and 5” (90-125mm)

above the floor. See Fig. 29.

SENSOR PROTECTION Fig. 32

 Before performing maintenance work in garage, such as,

power washing, painting, and other tasks; protect sensors

with provided sensor caps.

ROUTE WIRES Fig. 31

 Route wires along wall use staples (not provided) to secure

wiring to wall. Do NOT punch wire. Drive staples with only

enough force to hold wiring in place.

Be sure the wiring is routed away from all moving parts of

door and rail.

 Run wires along the top of the rail assembly and secure

them in wire holders.

Fig. 30

Fig. 29

Wall Stud

Lag Screws

Mounting Bracket

3.5” to 5” (90-125mm)

from floor

Sensor Bracket

Mounting Bracket

To Terminal 2

To Terminal 1

Mounting

on garage

floor

Twist Clip

Fig. 32

Photo Eye Sensor

Sensor Cap Protector

1/4” x 1-1/2”

Fig. 33

Receiver

Transmitter

Receiver

DUAL DOOR INSTALLATION Fig. 33

 In dual door installations, the transmitter (TX) and the receiver

(RX) photo eye sensors (as marked on each of the photo eye

components) should be mounted as indicate in Fig. 31. TX

and RX marks located on the back side of the transmitter

and receiver.

Wire Holder

Fig. 31

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Marantec 115694 Manuel d'instructions Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage Marantec 115694