Marantec 115694 Manuel d'instructions télécharger pdf (Page 10)

8-5. ATTACH RAIL TO OPERATOR HEAD

 Position operator with control panel facing the back of garage.

Rest operator head on cardboard or a protective surface on the

floor so the housing does not get scratched.

 Position rail onto operator chassis by lining up rail sprocket

opening with motor head shaft (Fig. 17). Make sure shaft

engages teeth inside rail sprocket. Press rail down firmly onto

the shaft and opener chassis. IMPORTANT: DO NOT USE A

HAMMER OR ANY OTHER TOOLS FOR THIS STEP.

 Position the two rail brackets over the backside of the rail as

shown in Fig. 17.

 Insert screws (M5 x 8.5) through bracket holes and into the

chassis holes. Tighten screws firmly to hold rail to head.

When fastening the rail to the operator,

use only the screws provided. Use of any

other screws may result in operator falling

from ceiling and causing damage

to persons or property in the garage.

12”

Fig. 15

Fig. 16

Rail

Mounting Bracket

Securement

Support

Clamp

8-4. RAIL ASSEMBLY (cont’d)

 Place first mounting bracket diagonally over the backside of the

rail (closed side) see Fig. 15. Make sure securement support

clamps clear the rail sides.

 Twist mounting bracket and secure it onto the rail 12” (30cm)

from sprocket end side of rail as shown in Fig. 15B.

 Place second mounting bracket over the backside of the rail close

to the rail connector. See Fig. 16.

 Secure bracket as shown on Fig. 15B.

Rail sprocket side

Rail connector

First mounting bracket

Second mounting bracket

Fig. 17

Standard Application

Alternate Rail Installation

(Space Saver Applications)

Sprocket

Opening

Rail

Motor Head

Shaft

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Marantec 115694 Manuel d'instructions Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage Marantec 115694